KYMCO DINK 200i Service Manual page 8

1. GENERAL INFORMATION
„ If the fuse is burned out, find the cause and
repair it. Replace it with a new one
according to the specified capacity.
„ After operation, terminal caps shall be
installed securely.
„ When taking out the connector, the lock on
the connector shall be released before
operation.
„ Hold the connector body when connecting
or disconnecting it.
„ Do not pull the connector wire.
„ Check if any connector terminal is bending,
protruding or loose.
1-5
Confirm
Capacity
„ The connector shall be inserted
completely.
„ If the double connector has a lock, lock
it at the correct position.
„ Check if there is any loose wire.
„ Before connecting a terminal, check for
damaged terminal cover or loose negative
terminal.
„ Check the double connector cover for
proper coverage and installation.
„ Insert the terminal completely.
„ Check the terminal cover for proper
coverage.
„ Do not make the terminal cover opening
face up.
„ Secure wire harnesses to the frame with
their respective wire bands at the
designated locations.
Tighten the bands so that only the insulated
surfaces contact the wire harnesses.
DINK200i/125