KYMCO DINK 200i Service Manual page 286

14. DINK 200 i:
FUEL SYSTEM (Auto Control Fuel Injection System)
Install the fuel injection assembly into the
intake manifold.
Install and tighten the bolt securely.
Connect the connector.
INSPECTION
Terminals
(Using a commercially available
multimeter)
Measure the fuel injection resistance.
Standard: 11.3±10% Ÿ (20°C/68°F)
(Using diagnostic tool)
Enter RECIVE SIGNAL MENU and then
read data in page 05 (refer to the "RECIVE
SIGNAL MENU (USING DIAGNOSTIC
TOOL)" section in this chapter).
Read the data:
Injection duration (ms)
14-44