Self-Diagnosis Procedures Without Dignostic Tool - KYMCO DINK 200i Service Manual

14. DINK 200 i:
SELF-DIAGNOSTIC
PROCEDURES WITHOUT
DIAGNOSTIC TOOL
SELF-DIAGNOSTIC PROCEDURES
Make sure the throttle position sensor
connector has connected and it is good.
Place the scooter on its main stand.
Turn the ignition switch ON the CELP will
light for two second then off.
It show the lamp work normal. If the ECU
detect any faulty then lamp will keep light.
Start the engine and let it idle.
If the CELP does not light or blink, the
system has no memory of problem data.
If the CELP light or blink, stop the engine
and read the failure codes, perform the
following:
Faults with a level one priority shall
cause the CELP to flash at the given rare
shown in Figure 1.
Faults with a level two priority shall
cause the CELP to light continuously.
Faults with a level three priority shall not
illuminate the CELP.
(1) Turn ignition switch to OFF, then open
and hold the throttle fully.
(2) Turn ignition switch to ON while the
CELP comes on, after 2 seconds the CELP
will be off.
FUEL SYSTEM (Auto Control Fuel Injection System)
CELP (Check Engine Lamp)
14-8