KYMCO DINK 200i Service Manual page 290

14. DINK 200 i:
(Using a commercially available
multimeter)
Input voltage
Put the side stand up and the engine stop
switch is at "RUN"
Disconnect the fuel pump connector.
Connect the multi-meter (+) probe to the
Red/Black terminal and the multi-meter (-)
probe to the Green terminal.
Turn the ignition switch to "ON" and
measure the voltage between the terminals.
There should be battery voltage for a few
seconds.
If there is battery voltage, replace the fuel
pump.
If there is no battery voltage, inspect the
following:
Fuse (20 A)
Fuel pump relay
ECU
Resistance
Measure the fuel pump resistance.
Standard: 1±0.2Ÿ (20°C/68°F)
FUEL SYSTEM (Auto Control Fuel Injection System)
14-48