KYMCO DINK 200i Service Manual page 224

13
. DINK 125:FUEL SYSTEM/CARBURETOR/
Pull float pin outs, then remove the float and
float valve.
Remove the slow jet.
Remove main jet.
Remove the needle jet holder and needle jet.
Remove the pilot screw, spring, washer and
O-ring.
Before pilot screw removal, slowly turn
the pilot screw clockwise and count the
number of turns until the screw is
lightly seated. Make a note of how
many turns were made so the screw can
be reset correctly.
FUEL PUMP/ FUEL TANK
Float
Float Valve
Slow Jet
Main Jet/Needle Jet Holder/Needle Jet
Pilot Screw/Spring/Washer/O-ring
DINK 200i/125
Float Pin
13-10