2
. EXHAUST MUFFLER/FRAME COVERS
DINK 200i/125
Remove the two bolts and rear spoiler stay.
Installation is in the reverse order of removal.
UPPER/LOWER HANDLEBAR COVER
Remove the six screws.
Remove the two screws, then remove the
upper handlebar cover.
Disconnect the throttle cable (DINK 125:
refer to the "CARBURETOR" section in the
chapter 13. DINK 200i: refer to the
"THROTTLE BODY /TPS" section in the
chapter 14), then pull the throttle cable out
from the lower cover.
Remove the lower cover.
Installation is in the reverse order of removal.
2-6