KYMCO DINK 200i Service Manual page 351

16
. REAR BRAKE/REAR FORK/REAR
WHEEL/REAR SHOCK ABSORBER
DINK 200i/125
Remove the dust seal (2) from the rear fork.
Remove the snap ring (3).
Turn the inner race of the bearing with your
finger.
The bearing should turn smoothly and quietly.
Also check that the bearing outer race fits
tightly in the rear fork.
Remove and discard the bearing if the race
does not turn smoothly and quietly, or if it fits
loosely in the rear fork.
Remove the bearing from the rear fork by
using a proper pipe.
16-22