KYMCO DINK 200i Service Manual page 10

1. GENERAL INFORMATION
„ After routing, check that the wire harnesses
are not twisted or kinked.
„ Wire harnesses routed along with
handlebar should not be pulled tight, have
excessive slack or interfere with adjacent
or surrounding parts in all steering
positions.
„ When a testing device is used, make sure to
understand the operating methods
thoroughly and operate according to the
operating instructions.
Do you understand
the instrument• •
„ Be careful not to drop any parts.
„ When rust is found on a terminal, remove
the rust with sand paper or equivalent
before connecting.
Remove Rust• •
1-7
„ Symbols:
The following symbols represent the
servicing methods and cautions included in
this service manual.
: Apply engine oil to the
specified points. (Use
designated engine oil for
Engine Oil
lubrication.)
Grease
: Apply grease for lubrication.
: Transmission Gear Oil (90#)
Gear Oil
• •
: Caution
: Warning
DINK200i/125