KYMCO DINK 200i Service Manual page 181

10
. A.C. GENERATOR/STARTER CLUTCH
INSTALLATION
Install the starter driven gear onto the
crankshaft.
Apply oil to the starter reduction gear shaft.
Install the starter reduction gear and shaft to
the right crankcase.
Install the flywheel onto the crankshaft by
aligning the key on the crankshaft with the
groove in the flywheel.
Before installation, check and make sure
that the inside of the flywheel is not
contaminated.
Starter Driven Gear
Shaft Reduction Gear
Key Groove
DINK 200i/125
Flywheel
10-8