KYMCO DINK 200i Service Manual page 252

14. DINK 200 i:
SELF-DIAGNOSIS RESET (CLEAR
FAILURE CODES) PROCEDURE
(1) Turn ignition switch to OFF, open and
hold the throttle fully.
(2) Turn ignition switch to ON while the
CELP comes on, after 2 seconds the CELP
will be off.
(3) Close the throttle fully when the CELP
comes on again.
(4) When the CELP begins to blink that the
CELP denotes the failure codes.
(5) The self-diagnosis memory data will be
erased when all the failure codes has
showed 5 cycles.
FUEL SYSTEM (Auto Control Fuel Injection System)
14-10