KYMCO DINK 200i Service Manual page 278

14. DINK 200 i:
TPS INSPECTION
(Using a commercially available
multimeter)
Input voltage
Turn ignition switch to ON with the engine
stop switch in the run position and put the
side stand up.
Disconnect throttle position sensor connector.
Connect the multimeter (+) probe to the
violet/red wire and the multimeter (-) probe
to the violet/green wire to measure the
voltage from the ECU input to throttle
position sensor.
Standard (20°C/68°F): 5±0.25 V
Be sure that the battery is in good
condition before performing this
measurement.
Resistance
Measure the resistance between the throttle
position sensor violet/red and violet/green
wire terminals.
Standard: 5K±30% Ÿ (20°C/68°F)
FUEL SYSTEM (Auto Control Fuel Injection System)
14-36