KYMCO DINK 200i Service Manual page 226

13
. DINK 125:FUEL SYSTEM/CARBURETOR/
INSPECTION
Carburetor body/jets cleaning
Check carburetor body and each jet for wear
or damage.
Clean all jets with a spray-type carburetor
cleaner and dry them using compressed air.
Clean all circuits of the carburetor
thoroughly-not just the perceived problem
area.
Clean the circuits in the carburetor body
with a spray-type cleaner and allow each
circuit to soak, if necessary, to loosen dirt
and varnish. Blow the body dry using
compressed air.
Some carburetor cleaning chemicals ,
especially dip type soaking solutions,
are very corrosive and must be handled
carefully. Always follow the chemical
manufacturer's instructions on proper
use, handling and storage.
Do not use a wire to clean the jets or
passageways. A wire can damage the
jets and passageways. If the
components cannot be cleaned with a
spray cleaner it may be necessary to
use a dip-type cleaning solution and
allow them to soak. Always follow the
chemical manufacturer's instructions
for proper use and cleaning of the
carburetor components.
After cleaning, reassemble the carburetor
with new seals.
FUEL PUMP/ FUEL TANK
DINK 200i/125
13-12