Water Temperature Sensor (Wts) - KYMCO DINK 200i Service Manual

14. DINK 200i:
WATER TEMPERATURE
SENSOR (WTS)
REMOMAL
Disconnect the WTS connector, then remove
WTS.
INSTALLATION
Replace a new washer.
Install and tighten the WTS to the specified
torque.
Torque: 2 kgf-m (20 N-m, 14 lbf-ft)
Connect the WTS connector.
INSPECTION
(Using a commercially available
multimeter)
Measure the throttle position sensor
resistance.
Standard:
703.8±40.9 Ÿ (60°C)
206.7±15.1 Ÿ (90°C)
111.1±7.8 Ÿ (120°C)
14-41
FUEL SYSTEM (Auto Control Fuel Injection System)