KYMCO DINK 200i Service Manual page 108

5
. ENGINE REMOVAL/INSTALLATION
ENGINE
REMOVAL/INSTALLATION
REMOVAL
• •
DINK 125 only:
Remove the air cleaner (refer to the
"AIR CLEANER" section in the
chapter 13).
Remove the carburetor (refer to the
"CARBURETOR" section in the
chapter 13).
• •
DINK 200i only:
Remove the air cleaner (refer to the
"AIR CLEANER" section in the
chapter 14)
Remove the two bolts from the intake
manifold.
Disconnect the O2 heater/O2 sensor
connector (refer to the "EXHAUST
MUFFLER" section in the chapter 2).
• •
DINK 200i only:
Remove a bolt from fuel hose guide (1).
Disconnect the fuel hose (2) from fuel
injector.
Disconnect the fuel vacuum hose (3)
and AICV vacuum hose (4) from the
intake manifold.
Disconnect the WTS connector (5)
from WTS.
Disconnect the coolant temperature
sensor connector (6) from coolant
temperature sensor.
Remove the throttle body and intake
manifold together from the cylinder
head.
DINK200i/DINK 125
5-2