Alternator Stator - KYMCO DINK 200i Service Manual

10
. A.C. GENERATOR/STARTER CLUTCH

ALTERNATOR STATOR

REMOVAL
Drain the engine oil (refer to the "ENGINE
OIL" section in the chapter 3).
Disconnect the alternator stator connectors
(refer to the chapter 17).
Remove the nine bolts from the right
crankcase cover and then remove the cover.
Remove the two dowel pins and gasket.
Remove the two pulse coil mount screws.
Remove the three stator mount bolts,
grommet and the stator from the right
crankcase cover.
10-3
Dowel Pins
Gasket
Pulser Coil
DINK 200i125
Stator