KYMCO DINK 200i Service Manual page 84

3
. INSPECTION/ADJUSTMENT
5. Install the new oil filter.
Make sure the rubber seal on the oil filter
facing the left crankcase.
6. Install the spring, O-ring and cap.
Cap bolt torque:
12 N-m (1.2 kgf-m, 8.6 lbf-ft)
7. Fill the crankcase with the recommended
grade oil and install the oil filler cap.
Oil capacity (after draining):
0.9 liter (0.95 US qt, 0.8 lmp qt)
8. Start the engine and let it idle for 2 3
minutes.
9. Stop the engine and check that the oil level
is at the upper level mark on the oil filler
cap/dipstick with the scooter upright on
firm, level ground. Make sure there are no
oil leaks.
3-11
DINK 200i125