4
. LUBRICATION SYSTEM
OIL PUMP
REMOVAL
Remove the flywheel and driven gear (refer
to the "STARTER CLUTCH" section in the
chapter 10).
Remove the bolt and then oil separator cover.
When removing and installing the oil
pump, use care not to allow dust or dirt
to enter the engine.
Pry the snap ring off and remove the oil pump
driven gear, then remove the oil pump drive
chain.
Remove the two oil separator bolts to remove
the oil pump.
4-3
Oil Separator Cover
Snap Ring
Oil Pump Driven Gear
Oil Pump
Oil Separator
DINK 200i/125
Bolts