Configuring Auxiliary I/O Board Relays; Disabling Alarms In Common Alarm List - HindlePower ATevo Series Operating/Service Instructions Manual

4 Startup & Configuration
To change the relay's latching status:
'Latching:' > select desired status
To change the relay time delay:
'Delay:' > increment/decrement to set point value

4.5.2 Configuring Auxiliary I/O Board Relays

Configuration of the relays on the optional Auxiliary I/O Board (A4)
is similar to the Common Alarm Relay configuration on the Main
Control Board (A1). This is because the Auxiliary I/O Board Relays
have the same three (3) configuration parameters. See Section 12.4
for configuration instructions.

4.6 Disabling Alarms in Common Alarm List

By default, the COMMON ALARM will activate when any ATevo alarm
is active. If you disable an alarm in the COMMON ALARM list the
alarm will activate, but it will not cause the COMMON ALARM to
activate.
49
ATevo