Checking Installation; Starting Up; Home Screen - HindlePower ATevo Series Operating/Service Instructions Manual

4 Startup & Configuration

4.1.3 Checking Installation

Prior to powering up ATevo for the first time, it is recommended that:
• You have followed installation instructions carefully.
• You check that ac input supply voltage and battery voltage
match information on ATevo nameplate.
• If ATevo features the Multi-Tap option, verify the ac input jumpers
on INPUT VOLTAGE SELECTION terminal block are correct for the
ac supply voltage (see Section 2.3.2).
• Open the front panel, and check battery polarity at the DC
Output Circuit Breaker (CB2+/-).

4.1.4 Starting Up

After confirming that all connections to ATevo are properly made,
start up as follows:
• Turn ON (close) AC Input Circuit Breaker (CB1) first. You should
hear a soft hum from ATevo as output increases.
• Main ATevo Display should start up and indicate dc output
voltage. If the display does not light, do not proceed. Turn OFF
(open) the AC Breaker (CB1) and recheck connections.
NOTICE
(CB2) first, it may trip due to the filter capacitor in-rush.
• Turn ON (close) the DC Output Circuit Breaker (CB2).
• If any error codes or alarms appear on the Main ATevo Display
and/or Alarm Indicator LEDs, see Section 7.
• Interpret the origin and resolution of the indication before
proceeding.

4.1.5 Home Screen

The default HOME screen appears after power up showing the
dc bus voltage and dc charger current, along with the status for
CHARGER MODE and EQUALIZE METHOD on the top line. CHARGE
MODES and EQUALIZE METHODs are described in Section 5.1.
ATevo will automatically switch back to the HOME screen if no
buttons are pushed for ten (10) minutes, or by pressing ESC one
or more times. Each press of ESC returns one level until HOME is
reached.
36
If you attempt to turn ON the DC Output Circuit Breaker
ATevo