Configuration Screens; Status Screens; Hindle Health System Screens - HindlePower ATevo Series Operating/Service Instructions Manual

3 Controls & Navigation
• 'Eqlz Mthd: Man' or 'Eqlz Mthd: Auto' will appear on the right
side of the top of the display to indicate that the EQUALIZE
METHOD is presently configured for MANUAL TIMER or
AUTOMATIC TIMER mode.
• If a Temperature Compensation (TempCo) Probe option is
installed and enabled, the present battery temperature and
normalized voltage set point will also appear on the display (see
Section 10 for more details on the TempCo option and display).

3.2.2 Configuration Screens

These screens are used for changing ATevo set points and
configuration. Many of these screens will be described in Startup
and Configuration, Section 4. Other configuration screens for
installed options will be described later in their respective installed
option sections.

3.2.3 Status Screens

ATevo Status screens do not permit any system changes, and are
used only for viewing information. Most of the status screens (e.g.
Event Log and Active Alarm List) are covered in Advanced Operation,
Section 6. The HOME screen can be thought of as a 'special' Status
Screen in that it can indicate dc output voltage (Vdc), dc output
current (Adc), and status of Equalize/Float mode and method.

3.2.4 Hindle Health System Screens

Hindle Health System screens are associated with the Hindle Health
button (HH). When (HH) is pressed, ATevo enters a user-assisted self-
diagnostic mode. Screens prompt the user to participate in a series
of tests that confirm that ATevo is operating correctly. For more
information on the Hindle Health System, see Section 8.
26
ATevo