Factory Default Binary Input Configuration; Software Configuration For Analog Inputs - HindlePower ATevo Series Operating/Service Instructions Manual

12.5.6 Factory Default Binary Input Configuration

Unless otherwise specified, the ATevo Auxiliary I/O Board (A4) will
ship from the factory with the following Binary Input Configuration:
Factory Default Binary Input Configuration
Binary
Input
#1
#2
#3
#4

12.6 Software Configuration for Analog Inputs

The Auxiliary I/O Board Analog Inputs are used to monitor, alarm,
and/or report on the status of any external transducer or sensor.
Each input can be scaled such that the value is reported in primary
units (°C, Vac, etc.).
The Analog Inputs can also generate alarms when their reported
values are below, above, or out-of-range of a configured valued.
ATevo assigns each input a unique generic name that may be
replaced by the user.
NOTICE
In the following subsections, Auxiliary I/O Board Analog Inputs default
names are specified by board number (see Section 12.3.1), and Analog
Input number on the associated board. For example: 'Aux 1 input AN2'
specifies Analog Input #2 on Auxiliary I/O Board #1.
Alarm
Name State
BI1-1 disabled
BI1-2 disabled
BI1-3 disabled
BI1-4 disabled
Software Configuration Naming
ATevo
12 Auxiliary Inputs/Outputs
Action
none
none
none
none
Active
State
high
high
high
high
113