Forced Loasd Shating Adapter (A13) - Optional; Ethernet Communications Adapter (A22) - Optional; Eliminator Capacitor (C2) - Optional; Ac Input Circuit Breaker (Cb1) - HindlePower ATevo Series Operating/Service Instructions Manual

2.1.7 Forced Load Sharing Comm Adapter (A13) - optional
Mounted similarly to Serial

2.1.8 Ethernet Communications Adapter (A22) - optional

Shown directly to bottom-left of Main Control Board (A1) on
silkscreen. Plugs into Main Board at P13. Supports DNP3 and
Modbus protocols via 10/100 copper Ethernet connection.
2.1.9 Eliminator Filter Capacitor (C2) - optional
Shown below Power Board on silkscreen. Mounted on bottom-left
under Power Board. Provides the additional ripple filtering, required
for the 'filtered eliminator' option.

2.1.10 AC Input Circuit Breaker (CB1)

Located in center of ATevo, about one third from bottom. Protects
ATevo ac wiring, and can be used to disconnect from ac source.

2.1.11 DC Output Circuit Breaker (CB2)

Located at bottom-center of ATevo. Protects ATevo dc wiring, and can
be used to disconnect ATevo from battery and system dc load(s).

2.1.12 Main Filter Inductor (L1)

Shown in center of silkscreen. Located on bottom-left of back wall. It
is part of the dc filter, lowering ripple.

2.1.13 Secondary Filter Inductor (L2)

Shown bottom-center of silkscreen. Located on bottom of back wall
to right of Filter Inductor (L1). It is also part of the dc filter.

2.1.14 Power Isolation Transformer (T1)

Shown at center of silkscreen. Located on back wall above the filter
inductors (L1/L2). Provides isolation and converts ac input voltage to
appropriate potential, prior to rectification.
NOTICE
ATevos with the multi-tap ac input option (smart part
code 'MT1/2'), feature a terminal block (TB-H#) mounted above
the AC Input Circuit Breaker (CB1) for voltage selection. Jumper
positions are shown on silkscreen to right of Power Isolation
Transformer (T1). See Section 2.3.
Communications
ATevo
2 Wiring
.
Adapter (A12)
13