HindlePower ATevo Series Operating/Service Instructions Manual page 140

13 Forced Load Sharing
To configure ATevo Load Share Charger ID:
MENU > COMMUNICATION > Port 'X' setup > Charger ID > select (A,
B, C, or D)
• Typically assign Primary charger as 'A' and Secondary chargers
as 'B', 'C', and 'D'
• Example below shows Secondary charger that's assigned ID 'B'.
Press the EDIT/ENTER button to accept the new selection. Press the
ESC button to return to the previous screen. If a port setting was
changes, the ATevo will prompt to RESET. Select YES to RESET the
ATevo. The new port settings will not become active until after the
ATevo is RESET.
124
ATevo