Startup & Configuration; Startup; Understanding Startup Sequence; Factory Settings Tables - HindlePower ATevo Series Operating/Service Instructions Manual

4.1 Startup

4.1.1 Understanding the Startup Sequence
ATevo is pre-configured to work with most common batteries and
loads without further adjustment.
When you start ATevo for the first time, the battery charger will:
• Use the FACTORY SETTINGS (float voltage, equalize voltage, etc)
listed in the following tables. These settings may be changed
after startup if necessary.
• Take about fifteen (15) seconds to start. Control circuitry will
'soft start' ATevo, such that dc output voltage and dc current
increase gradually to rated values.

4.1.2 Factory Settings Tables

Factory settings for each ATevo are summarized in the tables on the
following four (4) pages.
4 Startup & Configuration
ATevo
31