Relays Icon; Aux Inputs Icon; Testing Icon; Communication Icon - HindlePower ATevo Series Operating/Service Instructions Manual

6 Advanced Operation

6.1.6 Relays Icon

Refer to the following sections for details on:
• Changing Main board relay parameters - Section 4.5
• Changing Auxiliary Board relay parameters - Section 12.4
• Resetting latched alarm relays - Section 7.6

6.1.7 AUX Inputs Icon

6.1.8 Testing Icon

6.1.9 Communication Icon

ports support DNP3 and Modbus communications. Refer to the
supplementary ATevo Communications Manual (JA0102-54) for port
configuration instructions.
60
This icon shows relay configuration and control
options. Use it to configure relays and reset or
clear any latched alarm relays. To change a relay
configuration, execute the 'Relay configuration'
command then select the relay you wish to configure.
This icon is used to configure Binary Inputs and Analog
Inputs for up to four (4) Auxiliary I/O Boards. Each
board may have up to four (4) generic Binary Inputs
and four (4) generic Analog Inputs. See Section 12.5
for Binary Inputs, and Section 12.6 for Analog.
This icon displays the Battery Open Test configuration
and controls. See Section 7.7 for instructions on how to
start, schedule, and set up parameters for the Battery
Open Test.
This icon is used to configure optional communications
ports. ATevo supports three serial communications
ports and one Ethernet port. It shows all
communications ports, and whether or not they
are assigned and configured. Two (2) of the serial
ATevo