Basic Operation; Atevo Operating Modes; Changing Display Mode - HindlePower ATevo Series Operating/Service Instructions Manual

5 Basic Operation

5.1 ATevo Operating Modes

ATevo operating mode and method selections are primarily
controlled by three buttons (DISPLAY MODE, CHARGE MODE, and
EQUALIZE METHOD) at the far left of the control panel.
B A T T E R Y C H A R G E R
DISPLAY
MODE
CHARGE
MODE
EQUALIZE
METHOD

5.1.1 Changing Display Mode

HEALTHY OPERATION
The DISPLAY MODE button selects the HOME Screen display choices:
• DC Voltage and DC Amperes
• DC Amperes (only)
• DC Voltage (only)
• Time and Date
To change Display Mode:
DISPLAY MODE > one of 4 displayed choices
NOTICE
as the METER MODE button on legacy AT10.1 chargers. Its functionality is
equivalent in that it determines which measurements are to be shown on
the HOME screen.
52
MAIN
DISPLAY
ESC ALARMS
( ALARM RESET )
( LAMP TEST )
MENU
C H A R G E R H E A L T H
The DISPLAY MODE button is in the same relative location
ATevo
AC ON
HIGH DC VOLTAGE
LOW DC VOLTAGE
DC OUTPUT FAILURE
AC INPUT FAILURE
POSITIVE (+) GROUND
NEGATIVE (-) GROUND
COMMON ALARM
PRESS BUTTON TO PERFORM
A DIAGNOSTIC HEALTH CHECK
ACTION
REQUIRED
S T A T U S L I G H T S
SCAN TO VIEW :
MANUAL
STANDARD
DRAWINGS
SERVICE
INSTRUCTIONS
ATSERIES.NET
IMMEDIATE
ACTION