Table 8-7: Look-Up Table Access - Epson S1D13704 Technical Manual

Epson Research and Development
Vancouver Design Center
REG[15h] Look-Up Table Address Register
Address = FFF5h
n/a n/a
bits 5-4
bits 3-0
Note
Hardware Functional Specification
Issue Date: 01/02/08
RGB Index RGB Index
Bit 1 Bit 0
The S1D13704 has three 16-position, 4-bit wide Look-Up Tables, one each for red, green,
and blue. Refer to "Look-Up Table Architecture" for details. This register selects which
Look-Up Table position is read/write accessible through the Look-Up Table Data Register
(REG[17h]).
RGB Index Bits [1:0]
These bits select between the Red, Green, and Blue Look-Up Tables, and Auto-Increment
mode. The Green Look-Up Table is used in monochrome mode with these bits set to 10b.
See Note below.
Look-Up Table Address Bits [3:0]
These 4 bits select one of the 16 positions in the selected Look-Up Table. These bits are
automatically changed as the Look-Up Table Data Register is accessed. See Note below.
Accesses to the Look-Up Table Data Register automatically increment a pointer into the
RGB Look-Up Tables. The pointer sequence varies as shown in the table below.
REG[01h] REG[15h]
bit 5 bit 5
0 1
1 0
1 0
1 1
1 1
In Auto-Increment mode, writing the Look-Up Table Address Register automatically
sets the pointer to the Red Look-Up Table. For example, writing a value 03 into the
Look-Up Table Address Register selects Auto-Increment mode and sets the pointer to
R[3]. Subsequent accesses to the Look-Up Table Data Register move the pointer onto
G[3], B[3], R[4], etc.
Look-Up
Table
Address
Bit 3
*

Table 8-7: Look-Up Table Access

Look-Up Table
Selected
bit 4
Green/Gray Look-Up
0
Table
0 Auto-Increment
1 Red Look-Up Table
Green/Gray Look-Up
0
Table
1 Blue Look-Up Table
Look-Up Look-Up
Table Table
Address Address
Bit 2 Bit 1
Pointer Sequence
G[n], G[n+1], G[n+2],...
R[n], G[n], B[n], R[n+1], G[n+1],...
R[n], R[n+1], R[n+2],...
G[n], G[n+1], G[n+2],...
B[n], B[n+1], B[n+2],...
Page 65
Read/Write
Look-Up
Table
Address
Bit 0
S1D13704
X26A-A-001-04