Epson S1D13704 Technical Manual page 209

Epson Research and Development
Vancouver Design Center
13704VIRT Example
Program Messages
13704VIRT Display Utility
Issue Date: 01/02/08
1. Type "13704virt /a" to automatically pan and scroll.
2. Press "b" to change the bits-per-pixel from 1 bit-per-pixel to 2 bits-per-pixel.
3. Repeat steps 1 and 2 for the remaining color depths (4 and 8 bit-per-pixel).
4. Press <ESC> to exit the program.
ERROR: Too many devices registered.
There are too many display devices attached to the HAL. The HAL currently can manage only one
device.
ERROR: Could not register 13704 device.
A 13704 device was not found at the configured addresses. Check the configuration address using
the 13704CFG configuration program.
ERROR: Did not detect 13704.
The HAL was unable to read the revision code register on the S1D13704. Ensure that the S1D13704
hardware is installed and that the hardware platform has been set up correctly.
*
Page 5
S1D13704
X26A-B-004-02