Setting The Pattern Of The Generated Video; Installing The Test Module - Kramer VS-3232DN-EM User Manual

The Resolution DIP-switch is used to set the resolution of the generated video:
Available PC Resolutions for Generated Video (Jumper Off)
DIP-switch Position
1
OFF
ON
OFF
ON
Available HD Resolutions for Generated Video (Jumper On, Default)
DIP-switch Position
1
OFF
ON
OFF
ON
Figure 12 shows the Resolution DIP-switch with both switches off (up, default, 480p).

Setting the Pattern of the Generated Video

The Pattern button is used to set the pattern of generated video. There are 32 available
patterns. Press the button repeatedly to cycle through the patterns.

Installing the Test Module

By default, the test module is installed in the configuration. If you uninstalled the test module
in the configuration, it must be reinstalled before it can be used. When installing the test
module, the number of configured inputs and outputs must be increased by one. For example:
•
If your VS-3232DN-EM
VS-3232DN-EM
•
If your VS-3232DN-EM
VS-3232DN-EM
To install the test module in the configuration:
1. Press ESC, ENT and LOCK together.
The following is displayed:
Configuration Device
VS-3232DN-EM – Using the Test Video Card
Resolution
2
OFF 1024 x 768 @60Hz (default)
OFF 1280 x 1024 @60Hz
ON 1600 x 1200 @60Hz
ON 1920 x 1200 @60Hz
Resolution
2
OFF 480p (default)
OFF 720p
ON 1080i
ON 1080p
Figure 12: Resolution DIP-switch
has four inputs and eight outputs, you must configure the
as 5 x 9
has 32 inputs and 32 outputs, you must configure the
as 33 x 33
Kramer Electronics Ltd.
37