EDID Numbering Examples
The following EDID configuration is based on the port numbering shown in
requested switching configurations and their results.
EDID Request
EDID Sent
From OUT 11
Blank (256 bytes of 0xFF)
From IN 13
None (error message displayed)
AV data flow is: source >
VS-3232DN-EM
output is the AV source side. This is the reverse of the AV data flow direction.
When assigning EDIDs, note that the top row of the LCD display labeled OUTPUTS
relates to the ports connected to the sources (AV inputs), and the bottom row of the
LCD display labeled INPUTS relates to the ports connected to displays (AV outputs).
In
Figure
6, the EDID from EDID input 8
to all EDID outputs
Connecting to the VS-3232DN-EM via RS-232
You can connect to the
Note that a null-modem adapter/connection is not required.
To connect to the
•
Connect the RS-232 9-pin D-sub rear panel port on the
straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5 need to be connected)
to the RS-232 9-pin D-sub port on your PC.
Connecting to the VS-3232DN-EM via USB (VCOM)
The device's USB port can work as a virtual COM (VCOM) port. Verify that the USB port on
the PC that connects to the
install a driver to do this. You can use a tool such as Hercules or K-Config to use Protocol
3000 commands over USB (see
upgrade firmware over USB (see
VS-3232DN-EM – Connecting the VS-3232DN-EM
VS-3232DN-EM
> source, which means that the EDID input is the display side and the EDID
(VS-3232DN-EM
(VS-3232DN-EM
Input ports).
Figure 6: EDID Numbering Assignment
VS-3232DN-EM
via an RS-232 connection using, for example, a PC.
VS-3232DN-EM
via RS-232:
VS-3232DN-EM
Protocol 3000
Upgrading Firmware Using K-Upload
> display. EDID information flow is: display >
Output port 8) has been assigned
VS-3232DN-EM
is configured as a VCOM port. You may need to
on page 96). You can also use K-Upload to
Kramer Electronics Ltd.
Figure 5
and lists
unit via a 9-wire
on page 74).
15
Need help?
Do you have a question about the VS-3232DN-EM and is the answer not in the manual?