NEC Univerge NEAX 2000 IPS Command Manual page 385

COMMAND CODE TITLE:
35
Y=100-197
Y
No. MEANING
100
Terminating and Balanced
Network Impedance
NOTE 1:
If the echo occurs when you use the LDT card, set CM35 Y=100 to 07.
NOTE 2: When you use the ODT card for 2-wire E&M trunk, set CM35 Y=100 to 14/15.
NOTE 3:
When using Series 3600 software or later, a reset of the MP card is not required after this command
is set/changed. When changing the data with online, the data is valid after the trunk card is unplugged
and plugged in.
TRUNK ROUTE DATA
DATA
Impedance for other than EU
600 Ω (for regular/long line)
00
Balanced Network Impedance: complex
INITIAL
900 Ω
01
Balanced Network Impedance: complex
600 Ω (for short line/behind PBX)
02
Balanced Network Impedance: 600 Ω
07 LDT (for short line only)
13 DIT (for short line only)
14 2-wire E&M Trunk (for regular)
15 2-wire E&M Trunk (for long line)
NONE For regular
Impedance for EU
[Series 3400]
600 Ω (for short/long line)
00
Balanced Network Impedance: complex
- For PN-8COTU
- For PN-8COTR/PN-8COTR-A
SETTING DATA
MEANING
[Austria/Belgium/Denmark/Germany/
Italy/South Africa/Spain/Sweden/
Switzerland/The Netherlands/UK]
[Brazil/China/International]
– 361 –
CM35
: Initial Data
RELATED
COMMAND
NOTE 1
NOTE 2
NOTE 2
Continued on next page
NWA-008844-001 Rev.5.0
91ch3003.fm
NOVEMBER/15/2006