NEC Univerge NEAX 2000 IPS Command Manual page 156

COMMAND CODE TITLE:
08
BASIC SERVICE FEATURE
713 Station number sent to VMS when accessing VMS from a sub-
line assigned on D
715 Soft Keys for Call Screening feature
722 Sending of expanded information on Low Layer Compatibility
(LLC) information element for connection between ISDN ter-
minal/ISDN trunks
[Series 3200 R6.2 (R6.2)]
723 Check of the LAN cable of IP-PAD card is pulled out in Alter-
native Routing by a fault occurrence
[Series 3600]
728 Sending Service Set Tone to participants when a new partici-
pant attends the conference
[Series 3500]
734 Method of specifying the starting AMP relay circuit
[Other than EU]
[Series 3900]
NOTE 1: Set the second data to 0 when one Paging trunk is connected with multiple AMP relay circuits or with
two AMP relay circuits simultaneously.
NOTE 2: Set the second data to 1 when one Paging trunk is connected with one AMP relay circuit.
735 Method of connection the starting AMP relay circuit
[Other than EU]
[Series 3900]
NOTE 1: This command is effective only when the second data of CM08>734 is set to 0.
NOTE 2: Set the second data to 0 when one Paging trunk is connected with two AMP relay circuits simulta-
neously.
NOTE 3: Set the second data to 1 when one Paging trunk is connected with multiple AMP relay circuits or with
one AMP relay circuit.
BASIC SERVICE FEATURES
term
0 Subline station number
1 My Line station number
0 Available
1 Not available
0 Allow
1 Restricted
0 To check
1 Not checked
0 Not sent
1 To send
0 To specify by Access Code
1 To specify per trunk
0 To connect with two AMP relay
circuits
1 To connect with one AMP relay
circuit
– 132 –
: Initial Data
SETTING DATA
Continued on next page
NWA-008844-001 Rev.5.0
91ch3001.fm
JUNE/01/2007
CM08