NEC Univerge NEAX 2000 IPS Command Manual page 262

COMMAND CODE
14
(2) LEN is determined by setup of CM05 Y=0/4/6/8, refer to "LEN ASSIGNMENT" about location
of LEN at the initial setting.
(3) When deleting a station number (Single Line or D
ACD/UCD Group data (CM17) and Station Hunting Group data (CM18) in advance.
(4) When assigning Conference Trunk (ED00-ED03), a system reset is required after data setting.
(5) After assigning the data for PN-8RST (DTMF receiver), PN-2CSI/PN-4CSI (CSI), PN-2ILCA
(ISDN Terminal), you must unplug the circuit cards, then plug them again (After unplugging the
circuit card, you must wait for 30 seconds before plugging the circuit card again.).
(6) 5 or more digits station number should not be assigned when the following features with AP00 are
used.
• SMDR/PMS
• Front Desk Terminal/D
(7) Remote Site cannot accommodate the following FP/AP/LT cards.
8RSTA/G (PBR)
NOTE:
Four-line built-in PBR on the MP card is available at Remote Site.
When Remote Site is IPS
LT cards are restricted.
PN-4LDTA (LDT), PN-4LLCB (LLC), PN-8PFTB (PFT)
TITLE:
STATION NUMBER, TRUNK NUMBER, CARD NUMBER FOR EACH FP
Page A2
term
TIMS (CIS)
NOTE
DMR
term
), be sure to delete Call Pickup data (CM16),
DM
/IPS , in addition to the above conditions, the following
– 238 –
CM14
NWA-008844-001 Rev.5.0
91ch3002.fm
NOVEMBER/15/2006