NEC Univerge NEAX 2000 IPS Command Manual page 50

CONDITION
Commands which require a
reset of the MP card after
data setting.
• Press SW1 on the MP
card for system reset.
NOTE 1
INITIAL
NOTE 1: Before the MP card is reset, the system data backup must be executed by CMEC Y=6>0:0.
NOTE 2: A reset is not required after setting/changing CM04 Y=00, CM12 Y=17, and CM35 Y=100,
when using Series 3600 software or later. These commands are valid by the following opera-
tions respectively after setting/changing.
• CM04 Y=00 : pull out and reconnect the modular connector of the D
• CM12 Y=17 : pull out and reconnect LLC card
• CM35 Y=100: pull out and reconnect COT/IDT/LDT/ODT/DID cards
Conditions for Using Commands
COMMANDS
CM31 Y=0, Y=1>1, 2, 3,
Y=2, Y=3, Y=4, Y=5,
Y=6, Y=7, Y=8, Y=A>00,
01, 02, 04, 05, 06, 07, Y=B
CM35 Y=90, 91, 100
NOTE 2
CM42>47, 48, 66, 68, 74,
75
CM48 Y=0: 0200, Y=1:
0200, Y=2>09-11, Y=4
CM5A
CM60 Y=00, 01, 02, 04,
06, 16, 17, 22, 23, 27, 51
CM62
CMA0
CMA7
CMAA Y=14
CMAC
CMF8 Y=3>0, 1
– 26 –
CHAPTER 2 PRECAUTION
CONDITIONS FOR USING COMMANDS
MEANINGS
MFC/MF-ANI Trunk Data
Trunk Route Data
System Counter Data/Pad Data/Trunk
Restriction Class Conversion
Hold/Walk Up/Timed Reminder/Automated
Attendant Tone
Virtual Line-Virtual Trunk Path Setting
ATT Tenant Group, Functions
Tenants for Each ATT Group
Type of Data Terminal Interface
Originating Point Code (OPC) of CCH/IPT
Selection of DCH/CCH/DTI for T1, VIR-
TUAL AP Function
ISDN Functions
Serial No./ID Code/Program Revision Read
term
and DLC card
Continued on next page
NWA-008844-001 Rev.5.0
91ch2001.fm
JULY/01/2006