How To Load Resident System Program - NEC Univerge NEAX 2000 IPS Command Manual
Internet protocol server
Hide thumbs
Also See for Univerge NEAX 2000 IPS:
- Installation manual (619 pages) ,
- System manual (448 pages) ,
- Reference manual (421 pages)
Table of Contents
Advertisement
HOW TO LOAD RESIDENT SYSTEM PROGRAM
STEP1: On the MP card, set the SW3 to "C", then press the SW1.
STEP2:
After 30-40 seconds, confirm the status of the MJ/MN lamp on the PWR card.
• When the MN lamp lights, the office data has been normally registered.
• When the MJ lamp lights, the office data has not been normally registered.
Repeat STEP 1-STEP 2.
STEP3: On the MP card, set the SW3 to "0".
• The MP card has been changed to the ON LINE mode.
CHAPTER 4 RESIDENT SYSTEM PROGRAM
HOW TO LOAD RESIDENT SYSTEM PROGRAM
– 886 –
NWA-008844-001 Rev.5.0
91ch4001.fm
Advertisement
Table of Contents
