NEC Univerge NEAX 2000 IPS Command Manual page 53

CONDITION
Commands which can be
used only under Off-Line
mode of the AP00 card. See
"METHOD OF SETTING
ON-LINE/OFF-LINE
MODE". Page 32
AP OFF LINE
Commands which require a
reset of the CFTC card after
data setting.
• Set the Make Busy switch
to UP and then DOWN.
CFT INITIAL
Commands which require a
reset of the IPT card after
data setting.
• Set the Make Busy switch
to UP and then DOWN.
IPT INITIAL
Conditions for Using Commands
COMMANDS
CMD100
CMD101
CMD102
CMDD98
CMDD99
CMAA Y=10
CM0A
CMA7 Y=46
CMA7 Y=52-62
CMBA Y=04, Y=10,
Y=12-19, Y=21, Y=22,
Y=30-32, Y=34, Y=36-39,
Y=41, Y=42, Y=45-51
– 29 –
CHAPTER 2 PRECAUTION
CONDITIONS FOR USING COMMANDS
MEANINGS
Billing System Data Partial Clear for PN-
AP00-B with AP00 Program
Billing System Data All Clear for PN-AP00-
B with AP00 Program
Billing Memory Clear for PN-AP00-B with
AP00 Program
Billing Memory Clear for PN-AP00-B/PN-
AP00-D with MRCA Program
Billing System Data All Clear for PN-AP00-
B/PN-AP00-D with MRCA Program
Conference trunk partition for CFTC
LAN Interface Assignment
Connection method for IP trunks
IP Trunk Data
H.323/SIP Profile Data
Continued on next page
NWA-008844-001 Rev.5.0
91ch2001.fm
JULY/01/2006