NEC Univerge NEAX 2000 IPS Command Manual page 147

COMMAND CODE TITLE:
08
BASIC SERVICE FEATURE
531 DTG (Digital Tone Generator) for IP-CS
[For PHS]
[Series 3300]
534 System operation after the C.O./Tie line (via TRK-B) is com-
pleted when a station that has a C.O./Tie line call (via TRK-A)
on consultation hold is talking with another C.O./Tie line call
(via TRK-B)
[Series 3300]
537 Duration of displaying the name when the incoming call is
answered/the select key for Calling Number Display and Call-
ing Name Display or CID key is pressed
[Series 3300]
NOTE:
This command is effective from Series 3300 software up to Series 3600 software. When using Series
3700 R12.2 software or later, set this data by CM08>580.
538 Duration of displaying the destination information when the
outgoing call is answered by the destination via CCIS/ISDN
[Series 3300]
542 Type of Camp-On from ATTCON
[Series 3400]
543 Whether the step call is to be restricted or not
[Series 3500]
548 Selection of the Guest information displayed on an administra-
term
tive station (D
in left-side on upper line of LCD
[Series 3400]
549 Whether the PMS information for 8 characters display in left-
side on upper line of LCD is to be displayed on Attendant Con-
sole or not
[Series 3400]
553 Inquiry Dial Tone sent to a station makes SHF on Consultation
Hold
[For EU]
[Series 3500]
BASIC SERVICE FEATURES
/Attendant Console) for 8 characters display
0 NEAX 2000 IPS Specification
1 NEAX 2400 IPX Specification
0 Return to the original call
(via TRK-A)
1 ROT
0 Until call is finished/key is pressed
again
1 6 seconds
0 Until call is finished
1 6 seconds
0 Semi-Automatic Camp-On
1 Automatic Camp-On
0 Restricted
1 Allow
0 Display PMS information A/B
1 Display VIP/language
0 Display information assigned by
CM08>548
1 Not displayed
0 DT
1 SPDT
– 123 –
: Initial Data
SETTING DATA
Continued on next page
NWA-008844-001 Rev.5.0
91ch3001.fm
NOVEMBER/15/2006
CM08