NEC Univerge NEAX 2000 IPS Command Manual page 127

COMMAND CODE TITLE:
08
BASIC SERVICE FEATURE
212 When a caller encounters all ACD/UCD stations busy
213 Method to cancel Call Forwarding-All Calls/-Busy Line/-Don't
Answer (No Answer)
214 When a ACD/UCD station dials ACD/UCD Busy out code after
holding the call from a Tie Line/CCSA line on Consultation
Hold
215 When a ACD/UCD station dials ACD/UCD Busy out code after
holding the call from C.O. Line (DDD/FX/WATS) on Consulta-
tion Hold
216 Processor for Authorization Code/Forced Account Code
217 Processor for Remote Access to System (DISA) Code
220 Burst tone for Operator Monitoring
[Australia Only]
221 Tone sent to all parties on three party conference
NOTE: Setting data 0 is effective only when CM31 Y=0>0 is
04.
BASIC SERVICE FEATURES
0 Busy Tone is to be sent out
1 Caller is placed into queuing mode
0 Feature access code + Feature key
1 Feature access code + "*" key
0 ACD/UCD station hears Service Set
Tone, and returns to the call by Switch
Hook Flash
See CM17 Y=6 1 The call is disconnected ACD/UCD
station hears ROT
0 ACD/UCD station hears Service Set
Tone, and returns to the call by Switch
Hook Flash
See CM17 Y=5 1 The call is disconnected ACD/UCD
station hears ROT
0 To provide (MP)
1 Not provided (OAI)
0 To provide (MP)
1 Not provided (OAI)
0 Only Once
1 Every 4 seconds
0 Tone is not sent
1 Every 4 seconds
– 103 –
: Initial Data
SETTING DATA
See CM2A Y=00-14, A0
See CM2A Y=00-14, A0
Continued on next page
NWA-008844-001 Rev.5.0
JULY/01/2006
CM08
91ch3001.fm