How To Read This Chapter; Command Description - NEC Univerge NEAX 2000 IPS Command Manual
Internet protocol server
Hide thumbs
Also See for Univerge NEAX 2000 IPS:
- Installation manual (619 pages) ,
- System manual (448 pages) ,
- Reference manual (421 pages)
Table of Contents
Advertisement
HOW TO READ THIS CHAPTER
Information about each command is presented in the following order:
(1)
FUNCTION: The function of the command.
(2)
PRECAUTION: Precautions related to assigning data.
(3)
ASSIGNMENT PROCEDURE: The procedure for assigning data in CAT mode.
(4)
DATA TABLE: Detailed descriptions of the data.
In the description of each command, the following symbols are used.
: Initial data which is automatically loaded into the memory, after system initialization
by setting position "B" on SW3 of the MP, followed by a reset.
: Commands which require a reset of the MP card after data setting.
INITIAL
: Commands which require a reset of the AP00 card after data setting.
AP00 INITIAL
OFF LINE
: Commands which can be used only under Off-Line mode of the MP card.
To set Off-Line mode,
(1)
(2)
AP OFF LINE
: Commands which can be used only under Off-Line mode of the AP00 card.
CSH INITIAL
: Commands which require a reset of the CSH card after data setting.
DCH INITIAL
: Commands which require a reset of the DCH card after data setting.
: Commands which require a reset of the ICH card after data setting.
ICH INITIAL
: Commands which require a reset of the DTI/BRT/PRT/CCT card after data setting.
DTI INITIAL
CFT INITIAL
: Commands which require a reset of the CFTC card after data setting.
IPT INITIAL
: Commands which require a reset of the IPT card after data setting.
SIP INITIAL
: Commands which require a reset of the SIP card after data setting.
: Commands which require a reset of the IP-PAD card after data setting.
IP-PAD INITIAL
: Commands which require a reset of the BRT card after data setting.
BRT INITIAL
CIR INITIAL
: Commands which require a reset of the CIR card after data setting.
Refer to Chapter 4 for details on default data when the Resident System Program is loaded by setting po-
sition "C" on SW3 of the MP, followed by a reset.
You should confirm the meaning of initial data, and change or delete the data, if required.
Set SW3 on the MP card to "2" or "3".
Press SW1 on the MP card.
CHAPTER 3 COMMAND DESCRIPTION
– 44 –
HOW TO READ THIS CHAPTER
NWA-008844-001 Rev.5.0
91ch3001.fm
DECEMBER/02/2005
Advertisement
Table of Contents
