[Cm45] Purpose Of Pbr/Cft/Sdt - NEC Univerge NEAX 2000 IPS Command Manual

COMMAND CODE TITLE:
45
FUNCTION:
This command is used to define the purpose of PB (DTMF) Receiver (PN-8RST) and Conference trunk
(CFT). This command is also used to make the CFT, PBR and the Caller ID Sender (SDT) busy.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
+ 45Y + DE
ST
DATA TABLE:
Y
No. MEANING
0 Make busy con-
dition of PBR
1 PBR for incom-
ing call from Tie
line/DID
2 PBR for Auto-
mated Attendant
only
NOTE:
Set the PBR card number as follows.
00-15: PBR for a system that is not provided Remote PIM over IP feature or a Main site of
Remote PIM over IP feature. (00 is dedicated to built-in PBR of MP card.)
16-45:Built-in PBR for a Remote site (No. 01-30) of Remote PIM over IP feature.
PURPOSE OF PBR/CFT/SDT
PBR/CFT/SDT
+ + DE
NUMBER
(2-3 digits)
PBR/CFT/SDT NUMBER
No. MEANING
XX Z XX : PBR card number
Built-in PBR of MP
card: 00
PN-8RST: 01-45
Z : Circuit number
(0-3)
DATA
+ +
EXE
(1 digit)
SETTING DATA
DATA MEANING
0 Make busy
1 In service
0 Only for incoming
call from Tie line/
NOTE
DID
1 For both DTMF
station and Tie line/
DID
0 Only for Auto-
mated Attendant
1 For both DTMF
station and Tie
Line/DID/Auto-
mated Attendant
– 440 –
CM45
: Initial Data
RELATED
COMMAND
CM10/CM14>E2XX
CM10/CM14>E2XX
CM35 Y=01
CM30
CM41
Y=0>33, 43
CM10/CM14>E2XX
Continued on next page
NWA-008844-001 Rev.5.0
91ch3004.fm