[Cmd100] Billing System Data Partial Clear For Pn-Ap00-B With Ap00 Program - NEC Univerge NEAX 2000 IPS Command Manual

COMMAND CODE TITLE:
D100
FUNCTION:
This command is used to clear the data related only to the designated Command Code among the system
data for billing and to assign "0" as the data when using PN-AP00-B with AP00 program.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
+ + DE
ST
D100
Command Code of the data to be deleted
NOTE: Before use this command, make the PN-AP00-B card OFF LINE by switch setting as shown
below.
SW1
ON
BILLING SYSTEM DATA PARTIAL CLEAR FOR
PN-AP00-B WITH AP00 PROGRAM
+ + +
DE
DXXX CCC
4
3
: Position to be set
2
1
+
EXE
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
– 855 –
CMD100
AP OFF LINE
NWA-008844-001 Rev.5.0
91ch3009.fm