NEC Univerge NEAX 2000 IPS Command Manual page 113

COMMAND CODE TITLE:
08
BASIC SERVICE FEATURE
027 A hold tone is sent to overlap call
[Australia Only]
028 C.O. to C.O. transfer by station or attendant
NOTE:
This data is effective for C.O. trunks (Ground Start/
Loop Start) which receive a release signal from the
C.O.
029 When tandem call duration passes a predetermined time, the
call is disconnected or continued
(Related Command: CM35 Y=119, CM41 Y=0>54)
032 When a dial-in incoming call from a tie line or DID line is
addressed to vacant levels or unassigned stations, the call is
routed to a predetermined station, Attendant Console or Digital
Announcement Trunk
034 Receiving Tone when the destination goes on-hook while a line
is connecting to a destination.
[For EU]
[Series 3200 R6.2 (R6.2)]
NOTE: In Germany, you have to set setting data to 0.
035 Toll Restriction for an outgoing call by Speed Calling-Station
(Station Speed Dialing)
036 Buzzer indication when a call remains held at Attendant
Console over a preprogrammed period of time assigned by
CM41 Y=0>00 Buzzer indication for Automatic Recall
037 Select the detection method of incoming Ground Start trunks
Ring signal
NOTE: This is useful when AC induction is present on Ground
Start trunks.
BASIC SERVICE FEATURES
0 To send
1 Not sent
0 To allow
1 Not allowed
0 To disconnect
1 To continue
0 Restricted (ROT connection)
1 Predetermined station, ATTCON or
Digital Announcement Trunk
assigned by CM51 Y=06, 07
0 BT
1 ROT
0 Not provided
1 Provided
0 Not available
1 Available
0 Detect only, Ring cycle only
1 Detect Ring cycle and Ground Lead
– 89 –
: Initial Data
SETTING DATA
Continued on next page
NWA-008844-001 Rev.5.0
91ch3001.fm
NOVEMBER/15/2006
CM08