NEC Univerge NEAX 2000 IPS Command Manual page 136

COMMAND CODE TITLE:
08
BASIC SERVICE FEATURE
380 Interval of ringer until detecting a ringing frequency from the
main PBX or Centrex.
Ringing is sent from D
quency.
381 Interval of ringer until detecting a ringing frequency from the
main PBX or Centrex.
Ringing is sent from D
quency.
NOTE: Effective only when the 2nd data of CM08>380: 0.
382 Lamp indication of D
call from main PBX or Centrex.
The lamp is lit until detection of the ringing frequency.
386 Destination setting of Call Forwarding-All Calls/Busy Line/
Don't Answer (No Answer)-Outside or Split Call Forwarding-
All Calls/Busy Line/Don't Answer (No Answer)-Outside by
entering only a trunk access code
388 Holding/held party control for Music on Hold tenant basis
term
390 D tone ringer selection
NOTE 1: Set "0" (Available) by CM08>262 to allow the ring
test tone to be heard when using the "Feature + 3"
operation.
NOTE 2:
When the ring tone 600 + 700 (Hz) is specified in
CM15 Y=83, 84 and/or CM35 Y=34, the ring tone
selection key of D
391 Lamp indication on D
BASIC SERVICE FEATURES
term
until detection of the ringing fre-
term
until detection of the ringing fre-
term
until detecting the kind of incoming
term
is ineffective.
term
0
1
0
1
0
1
0
1
0
1
0
INITIAL
1
0
1
INITIAL
– 112 –
: Initial Data
SETTING DATA
As per CM08>381
As per CM35 Y=33
No Ringer
Ringing Tone (0.5 seconds) is sent
once
Red steady light
120 IPM flash (As per CM35 Y=32)
Restricted
Allowed
Held party control (tenant)
Holding party control (tenant)
By pressing Feature key and dialing 3
[2nd data=0 is set when Resi-
dent System program is
loaded.]
As per CM15 Y=83, 84, 93, CM35
Y=34, 164
Special
Standard
Continued on next page
NWA-008844-001 Rev.5.0
CM08
NOTE 1
NOTE 2
91ch3001.fm