[Cmf8] Serial No./Id Code/Program Revision Read - NEC Univerge NEAX 2000 IPS Command Manual

COMMAND CODE TITLE:
F8
FUNCTION:
This command is used to assign the ID code to protect a copy of the Key FD and to read a program re-
vision. DO NOT USE this command without the assistance of a NEC engineer.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
ST + F8Y + DE
DATA TABLE:
Y
No. MEANING
0 Display of Serial
number
[North America
Only]
3 ID Code for Key FD
[North America
Only]
SERIAL No./ID CODE/PROGRAM REVISION READ
1ST DATA
+ + DE +
(1-4 digits)
1ST DATA
DATA
00 MP Serial No.
01-16 Key FD Serial No.
0 ID Code Entry/Display/
Cancel
1 Special ID Code Entry
Display of remaining time
for Special ID Code
2 Display of Validity/Invalid-
ity for entered ID Code
2ND DATA
+ EXE
(1-30 digits)
MEANING
NOTE 1
INITIAL
NOTE 2
INITIAL
– 779 –
: Initial Data
2ND DATA
DATA MEANING
X....X Serial No.
(Maximum 15 digits)
X: ASCII Code
(20H-7DH)
NONE No data
X....X ID Code (30 digits)
X=0-9
CCC Cancel
NONE No data
4320 –
0 0 minute
7200 7200 minutes (5 days)
0 Valid
1 ID Code just entered
2 Invalid
NONE ID Code not entered
Continued on next page
NWA-008844-001 Rev.5.0
CMF8
91ch3008.fm
JULY/01/2006