[Cm72] Stored Number For Speed Calling-System (System Speed Dialing) - NEC Univerge NEAX 2000 IPS Command Manual

COMMAND CODE TITLE:
72
FUNCTION:
This command is used to enter the stored number or character for Speed Calling-System (System Speed
Dialing) feature into the memory allocated with CM71.
PRECAUTION:
(1) When displaying the data, the access code corresponding to the Memory Slot number is indicated
by the very first
digits of the stored number exceeds 16, the 17th to 26th digits are indicated by the next
(2) Data can only be changed when the access code is displayed. Enter the data in the following order;
new access code, comma, the called number, and
following order; access code on the display, comma, "CCC", and
(3) If "C" is inserted in the called number, when using Speed Calling-System (System Speed Dialing)
for an outgoing Tie Line call, it can be used as a fixed-length pause (1.5 seconds). To provide a
programmable pause with the stored number, insert "D" instead of "C". The length of the
programmable pause is assigned with CM41 Y=0>38.
(4) The stored number, for Speed Calling-System (System Speed Dialing), is assigned for each
Memory Slot number, not for the abbreviated code of each calling party. When assigning stored
numbers, the correspondence between Memory Slot numbers and abbreviated codes is first to be
determined for each kind of calling party, and then the stored numbers are to be assigned according
to the determined correspondence, with each exclusive memory area assigned in CM71 taken into
consideration.
ASSIGNMENT PROCEDURE:
ST + 72Y + DE +
STORED NUMBER FOR SPEED CALLING-SYSTEM
(SYSTEM SPEED DIALING)
, and the stored number is indicated by the next
DE
MEMORY SLOT NUMBER
(3 digits)
EXE . For clearing the data, enter the data in the
STORED NUMBER
+ DE +
(Maximum 32 digits)
– 522 –
. When the number of
DE
.
EXE
+ EXE
NWA-008844-001 Rev.5.0
CM72
.
DE
91ch3005.fm