NEC Univerge NEAX 2000 IPS Command Manual page 54
Internet protocol server
Hide thumbs
Also See for Univerge NEAX 2000 IPS:
- Installation manual (619 pages) ,
- System manual (448 pages) ,
- Reference manual (421 pages)
Table of Contents
Advertisement
CONDITION
Commands which require a
reset of the SIP card after
data setting.
• Set the Make Busy switch
to UP and then DOWN.
SIP INITIAL
Commands which require a
reset of the IP-PAD card
after data setting.
• Set the Make Busy switch
to UP and then DOWN.
IP-PAD INITIAL
NOTE:
SIP initial is required only when SIP Trunk Source IP Address Check is provided by CM0A
Y=79: 0.
Conditions for Using Commands
COMMANDS
CM0A
CMBA Y=04, Y=10,
Y=13, Y=14, Y=21, Y=30,
NOTE
Y=31, Y=137
CM0A
– 30 –
CHAPTER 2 PRECAUTION
CONDITIONS FOR USING COMMANDS
MEANINGS
LAN Interface Assignment
H.323/SIP Profile Data
LAN Interface Assignment
NWA-008844-001 Rev.5.0
91ch2001.fm
NOVEMBER/15/2006
Advertisement
Table of Contents
