NEC Univerge NEAX 2000 IPS Command Manual page 72

COMMAND CODE TITLE:
00
NOTE 1: MP Built-in FP is used for controlling Legacy line/trunk cards. Only FP No. 00 is available.
NOTE 2: Virtual FP is used for controlling Peer-to-Peer connection between D
and via CCIS.
NOTE 3:
CM05 Y=4/8 NONE data are as follows.
FP No. 00: PIM0 and PIM1
FP No. 01: PIM2 and PIM3
FP No. 02: PIM4 and PIM5
FP No. 03: PIM6 and PIM7
FP No. 04-63: No data
AP No. 04-15, 20-63: No data
ASSIGNMENT PROCEDURE:
ST + 00 + DE +
DATA TABLE:
1ST DATA
DATA
1 System data memory all clear for the TDSW-
based PBX system (8 PIMs)
11 System data memory all clear for the IP-
based PBX system (1 PIM + 7 Virtual PIMs)
12 System data memory all clear for the IP-
based PBX system (2 PIMs + 6 Virtual
PIMs)
13 System data memory all clear for the IP-
based PBX system (3 PIMs + 5 Virtual
PIMs)
14 System data memory all clear for the IP-
based PBX system (4 PIMs + 4 Virtual
PIMs)
SYSTEM DATA MEMORY ALL CLEAR
MEMORY AREA
+
DESIGNATION
(1/2 digits)
MEANING
DE + CCC + EXE
DATA
CCC Clear
CCC Clear
CCC Clear
CCC Clear
CCC Clear
– 48 –
OFF LINE
term
IPs on intra-office
2ND DATA
MEANING
Continued on next page
NWA-008844-001 Rev.5.0
CM00
91ch3001.fm