Interlogix NS3552-8P-2S-V2 User Manual page 385

---- ------ ------------ --------- -------- -------- -------- -------
1 Permit Disabled
Security Network ACL Policy
Description:
Set or show the ACL port policy.
Syntax:
Security Network ACL Policy [<port_list>] [<policy>]
Parameters:
<port_list>: Port list or 'all', default: All ports
<policy> : Policy number (1-8)
Default Setting:
1
Example:
Set ACL policy 2 for port 1
NS3552-8P-2S-V2:/> security network acl policy 1 2
Security Network ACL Rate
Description:
Set or show the ACL rate limiter.
Syntax:
Security Network ACL Rate [<rate_limiter_list>] [<rate_unit>] [<rate>]
Parameters:
<rate_limiter_list>: Rate limiter list (1-16), default: All rate limiters
<rate_unit>
<rate>
Default Setting:
1
Example:
Set rate limit value in 100 for port 1
NS3552-8P-2S-V2:/>
security network acl rate 1 100
Security Network ACL Add
Description:
Add or modify Access Control Entry (ACE).
If the ACE ID parameter <ace_id> is specified and an entry with this ACE ID
already exists, the ACE will be modified. Otherwise, a new ACE will be added. If
the ACE ID is not specified, the next available ACE ID will be used.
If the next ACE ID parameter <ace_id_next> is specified, the ACE will be placed
before this ACE in the list. If the next ACE ID is not specified, the ACE will be
placed last in the list.
If the Switch keyword is used, the rule applies to all ports.
If the Port keyword is used, the rule applies to the specified port only. If the Policy
keyword is used, the rule applies to all ports configured with the specified policy.
The default is that the rule applies to all ports.
NS3552-8P-2S-V2 User Manual
Disabled Disabled Disabled Disabled 0
: IP flags: pps|kbps, default: pss
: Rate in pps (0-100) or kbps (0, 100, 2*100, 3*100, ..., 1000000)
Chapter 6: Command line mode
383