Sensor Simulation - Emerson Micro Motion 5700 Configuration And Use Manual

Complete the configuration
March 2019
Option
4. For temperature, set Wave Form as desired and enter the required values.
Option
Fixed
Sawtooth
Sine
5. Observe the system response to the simulated values and make any appropriate changes to the
transmitter configuration or to the system.
6. Modify the simulated values and repeat.
7. When you have finished testing or tuning, disable sensor simulation.

11.1.1 Sensor simulation

Sensor simulation allows you to test the system or tune the loop without having to create the test conditions
in your process. When sensor simulation is enabled, the transmitter reports the simulated values for mass
flow, density, and temperature, and takes all appropriate actions. For example, the transmitter might apply a
cutoff, activate an event, or post an alert.
When sensor simulation is enabled, the simulated values are stored in the same memory locations used for
process data from the sensor. The simulated values are then used throughout transmitter functioning. For
example, sensor simulation will affect:
• All mass flow rate, temperature, and density values displayed or reported via outputs or digital
communications
• The mass total and mass inventory values
• All volume calculations and data, including reported values, volume totals, and volume inventories
• All mass, temperature, density, or volume values logged to Data Logger
Sensor simulation does not affect any diagnostic values.
Unlike actual mass flow rate and density values, the simulated values are not temperature-compensated
(adjusted for the effect of temperature on the sensor's flow tubes).
186
Required values
Maximum
Required values
Fixed Value
Period
Minimum
Maximum
Period
Minimum
Maximum
Micro Motion Model 5700 Transmitters with Configurable Outputs
Configuration and Use Manual
MMI-20025166