Configure Global Batching Parameters Using Prolink Iii - Emerson Micro Motion 5700 Configuration And Use Manual

Configure process measurement applications
March 2019
If Maximum Fill Time is set to 0, the control is disabled and no maximum time is applied to batches.
5. (Optional) For two-stage batching, set the following parameters:
Two-stage batching is a batch that is run on a gas and liquid mixture flowing through a pipeline.
Parameter
Number of Stages
Configure Presets by
6. Optional: To enable Reset on Start, select Yes.
Option
Enabled (Yes)
Disabled (No)
The default setting of Reset on Start is Enabled. If the custody transfer application is installed, Reset on
Start is set to No and cannot be changed.

Configure global batching parameters using ProLink III

The global batching parameters apply to all batch presets and all batches.
Procedure
1. Choose Device Tools > Configuration > Batcher.
2. Set Flow Source to the process variable that will be used to configure and measure the batch.
Option
Mass Flow Rate
Volume Flow Rate
API Corrected Vol Flow
GSV Flow (only if configured)
92
Value
Set to 2.
Setting this parameter to 1 disables two-stage batching.
% Target
Quantity
Description
The batch totalizer resets when the operator starts the batch.
The operator must press RESET before starting a new batch.
Description
The batch is measured by mass, using the current mass unit.
The batch is measured by volume, using the current volume
unit.
The batch is measured using the API calculated correction
factor.
The batch is measured using the Gas standard volume flow
rate.
Micro Motion Model 5700 Transmitters with Configurable Outputs
Configuration and Use Manual
The values for Open Primary, Open Secondary, Close
Primary, and End Warning are each configured as a
percent of target.
The values for Open Primary and Open Secondary are
each configured as a quantity at which the valve should
open. The values for Close Primary and End Warning
are each configured as a quantity that is subtracted
from the target.
MMI-20025166